Package includes 1 fuel cell containing flammable liquefied gas.

• Do not store above 120 F (49 C). • Keep away from heat sources, sparks or open flame. • Do not crush or puncture carton. • Do not store in rooms used for human habitation or in passage to these rooms.

SCREWS

Installing UltraCon fasteners is much faster & easier when using one of Elco’s installation tools.

• Drill hole with specially sized UltraCon masonry drill bit. Proper drill bit diameter is critical for proper fastener performance. Drill hole a minimum ¼” deeper than fastener length to prevent fastener from bottoming-out.

• Slide the sleeve of the installation tool in use over the drill bit, locking it onto the drill bit adapter.

• Drive fastener. The drive socket in use will automatically disengage the fastener when seated.

SCREWS

For all powers products, operators and bystanders should always wear eye, hearing, and other appropriate protection as required. Read and follow the installation procedures for the specific fastening product used.

• HEAD DIA: 0.300

• LENGTH: 2-1/2”

SCREWS

For all powers products, operators and bystanders should always wear eye, hearing, and other appropriate protection as required. Read and follow the installation procedures for the specific fastening product used.

• 0.145” Dia. • 7/8” Washer

SCREWS

27 Caliber safety strip loads for use in powers fasteners models R3500, Ramset Model SA270, and Hilti Models DX36M, DX350 and DX451 Tools. Power level 4. Discharging powder actuated tools in poorly ventilated areas, cleaning powder actuated tools, or handling powder loads may result in exposure to lead, a substance known to cause birth defects, reproductive harm, and other serious physical injury. Have adequate ventilation at all times. Wash hands thoroughly after exposure.

SCREWS

For all powers products, operators and bystanders should always wear eye, hearing, and other appropriate protection as required. Read and follow the installation procedures for the specific fastening product used. Powder pin and load selection guide.

• With 7/8” Washer. • Furring Strip & Plywood to Concrete & Block.

SCREWS

Grabber Cement Board Screws have been specifically designed for use with high density exterior sheathing. These exterior grade corrosion resistant fasteners have a 40” (10.5 mm) wafer head with nibs to facilitate seating and minimize strip out. Grabber sharp point screws are for use for the attachment of these boards to wood or steel from 25 to 20 gauge.

SCREWS